OK, I need a cutting and face mold for a spiral handrail with these parameters...
Center-line radius = 29"
Unit rise = 9.04
Unit run along the center-line = 15.71"
Floor plan = 360 degrees
Number of segments = 6
handrail width = 2.75"
handrail height = 2.875"
I don't care how or which method or book you choose to use but any of the face molds from any of you, must look alike and with the same bevels or be in error.
FYI, this is no practice exercise for me but a typical order and one which I'm working on now.
Center-line radius = 29"
Unit rise = 9.04
Unit run along the center-line = 15.71"
Floor plan = 360 degrees
Number of segments = 6
handrail width = 2.75"
handrail height = 2.875"
I don't care how or which method or book you choose to use but any of the face molds from any of you, must look alike and with the same bevels or be in error.
FYI, this is no practice exercise for me but a typical order and one which I'm working on now.
Comment