Announcement

Collapse
No announcement yet.

Leaking Deck Over Garage

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Leaking Deck Over Garage

    Homeowner has a 30x30 walkout deck over his finished attached garage. Deck is on I-beam joists with 5/8" plywood glued and screwed. Previous contractor then added 3/8" osb and covered it in LinX truck box liner spray (or Rhino spray or a similar brand). It leaked. COntractor came back and rolled on an armourthane product. It leaked. (that is all I know about the second product) Contractor has not returned. Homeowner has tarred down tarpaper and other sheet prodcuts over leaky spots and has redone his garage ceiling (interior) twice now. Wants to replace the deck surface with a long lasting product that doesn't leak.
    Challenges:
    -Home is stucco with a flashing ledge on which the base of the stucco sits over the deck. This height cannot be adjusted. It is currently 3/4"-1" above the deck.
    -Around the deck are 6- 10x10 stuccoed posts with no base flashing!?!
    -There are three separate doors leading onto the deck and as of now the deck height is level with the TOP of the aluminum threshholds on them so it cannot go higher. If it wasn't stucco I would consider moving the doors up.
    -Can't build a roof b/c i dont feel comfortable doing it w/o engineered drawings and he wont get them. (I do think a deck surface product will work.)

    I will remove the existing roll on prodcut and the 3/8 OSB. Then, I am thinking of applying a rolled vinyl product like Duradek or Dek-master. However, the triangle shaped cantstrip flashing will not fit under the stucco drip sill so how to flash the vinyl to the home and posts? ANd how to flash it to the door threshholds? I don't like the idea of a bead of silicone being the only barrier to water. Any comments on the longevity of these vinyl products?

    Or, perhaps I could apply a roll on product like this

    http://www.ducan.com/rd_overview.php or another brand like this

    http://www.homehardware.ca/en/exclusive-to-home_99.htm

    I am not as familiar with these but I do like the idea of a roll on product b/c then I can roll under the existing stucco drip sill on the bottom of the wall and roll right up to and even right up the posts an inch or so b/c they have no drip flashing or bottom bead to roll under.

    OR, perhaps I could put down Commercial Ice and Water on the original 5/8" (or some other product) then use 1/2" furring strips and lay a deck surface over the deck with 5/4 x5" pt bullnosed decking?? (or some other surface) Height would be a concern, esp. around the door threshholds and i am not sure how to ensure the screws that hold the decking down and the screws/nails that hold the furring strips down will be sealed. ??

    I am open to other suggestions. I can post pics if someone suggests how to do this and feels that it would help them to formulate a solution or suggestion.

    What do you think would work best? I operate under a "meticulous workmanship" motto. I want to do this the best way possible. (I also want to help the poor fellow out. =) He has had a leaking deck on and off for 15 years now and water leaks are so insidious. =(

    Any comments are appreciated.
    Thanks.
    Last edited by lockhart76; 06-11-2008, 12:21 AM. Reason: I guess i do know how to make links
    I am learning all the time. The tombstone will be my diploma. ~Eartha Kitt

  • #2
    Re: Leaking Deck Over Garage

    You aren't going to like any of the answers you're going to get.....

    After 15 years of the deck leaking there is likely to be plenty of rot and other damage to the deck and I-joists. You'll need to uncover, remove and replace whatever is damaged.

    I like the Mer-Krete 747 Exterior Dual Membrane System
    http://www.merkote.com/merkrete/dual747-1.htm
    which I had installed on two decks recently. Use stainless steel flashing, especially over the door threshold, and around the posts, and appropriate stucco flashing. The posts must be completely flashed so they are waterproofed. You'll have to redo the stucco to get the stucco flashing at the right height. You'll also need to raise the doors an inch or two so the threshold is high enough. See the MerKrete technical info for details. (There are other systems that will work, some better than others). The amount of work to fix it right will be extensive.
    HERS Rater • BPI Building Analyst • BPI Envelope Professional
    Certified Green Building Professional • Certified Existing Home Advisor
    General Building Contractor • Asbestos Certification • Hazardous Substance Removal Certification • EPA Approved Lead-Safe Contractor • Locksmith
    PMP • ESEP • CISSP

    Comment


    • #3
      Re: Leaking Deck Over Garage

      AND if you aren't permitted to get into the stucco and door sills to detail the job out right, the job won't work and you'll be the one hearing from the lawyers. WALK AWAY!

      Comment


      • #4
        Re: Leaking Deck Over Garage

        I am in Canada. Can I even get merkrete here?
        I am learning all the time. The tombstone will be my diploma. ~Eartha Kitt

        Comment


        • #5
          Re: Leaking Deck Over Garage

          Originally posted by NW Architect
          WALK AWAY!
          Ditto.....
          You will ask what goal the U.S. is pursuing? .... their external debt is huge, and ruining other countries is their customary method. Even ownership of the global 'printing press' is no longer helping. Nor is full control over NATO, None of that if enough for the 21st century colonizers. They don't just need to preserve the dollar as the only global currency but also to get their hands on the economic wealth of other large powers and regions. - Sergei Naryshkin

          Comment


          • #6
            Re: Leaking Deck Over Garage

            No more "dittos" permitted. =)

            I realize the general consensus is to walk away, but this job presents unique challenges. I thought someone might have a creative way of solving them while leaving the stucco intact.
            I am learning all the time. The tombstone will be my diploma. ~Eartha Kitt

            Comment


            • #7
              Re: Leaking Deck Over Garage

              Lockhart,
              I thought I'd offer a slightly different take on the walk away approach. If you are going to take on the job you must be aware of not only the proper method of repair both in craftsmanship and building code requirements, but the liability which you take on for it. I don't know what the law is like in Canada, but in the USA contractors are perceived as evil. If we do something it is expected to be right whether you put in warranty exclusions or not. Local building officials will inspect to make sure we didn't do anything illegal from a code perspective. Usually, the law will protect the homeowner while hammering you with the phrase you are the professional contractor you knew or should have known how to do this right and didn't. Therefore you are guilty! Think mold and mildew and major liability. That substructure is probably junk and needs to be replaced. If the homeowner can't afford to do it right don't do it at all. Remember no good deed will go unpunished no matter your intentions.

              Good Luck.
              I started out with nothing. I still have most of it left.

              Comment


              • #8
                Re: Leaking Deck Over Garage

                This deck is suspended over a roof, correct? Fix the roof and re-attach the deck.

                If the deck is the roof, oops! Remove it and use smaller framing, IF it won't create something 'less than code'.

                I guess you could google Tom Hay and ask him. He invented the Poly roofs and SprayMax.
                Frank

                Eternal Vigilance is the Price for Freedom. And for Lasting Quality.
                Slate Repairs, Richmond, Va.
                Domain Names and Websites

                Comment


                • #9
                  Re: Leaking Deck Over Garage

                  Code is the MINIMUM requirement and what you are proposing(op) won't even meet that.

                  Therefore, either do it right or don't do it.

                  Sorry for the customer's bad fortune, don't make it yours.

                  Comment


                  • #10
                    Re: Leaking Deck Over Garage

                    Reglet flashings are a pretty effective way of flashing to stucco walls, and can work on the posts, too. I'd check into replacing the plywood and rotted joists, and using an EPDM system or torch-down system. Don't rely on rolled or sprayed on "waterproofing coatings." They fail in short order. And don't use OSB. Get some real plywood.

                    Comment


                    • #11
                      Re: Leaking Deck Over Garage

                      From what i know of reglet flashings, they need to be installed and then stuccoed over? To attach them in a renovation scenario you would need to cut out stucco, attach, and then stucco over the flange?
                      Last edited by lockhart76; 06-14-2008, 12:24 AM.
                      I am learning all the time. The tombstone will be my diploma. ~Eartha Kitt

                      Comment


                      • #12
                        Re: Leaking Deck Over Garage

                        Is it possible to cut out the stucco and then place the upper edge of the flashing under the stucco or under the stucco, mesh and paper?
                        I am learning all the time. The tombstone will be my diploma. ~Eartha Kitt

                        Comment


                        • #13
                          Re: Leaking Deck Over Garage

                          Extremely difficult to do:
                          1. You must cut away some stucco without nicking the building paper
                          2. You must have sound building paper at the bottom of the wall (where pooling and leeking has probably been occuring
                          3. You must cut some lath staples up behind in-place stucco
                          4. You must slip a new flashing up under that sound, in-place, building paper that remains behind the existing stucco
                          5. You must patch back a small strip of stucco and hope it matches the existing stucco well enough to make your client happy

                          Comment


                          • #14
                            Re: Leaking Deck Over Garage

                            Originally posted by lockhart76 View Post
                            No more "dittos" permitted. =)

                            I realize the general consensus is to walk away, but this job presents unique challenges. I thought someone might have a creative way of solving them while leaving the stucco intact.
                            Creative yes, effective no

                            This is a good one to begin practcing not taking short cuts, or not being being creative, whichever you want to call it.
                            Bill R
                            www.train2rebuild.com
                            Twitter

                            Comment


                            • #15
                              Re: Leaking Deck Over Garage

                              Originally posted by NW Architect View Post
                              5. You must patch back a small strip of stucco and hope it matches the existing stucco well enough to make your client happy
                              You could always go with a different color and texture in this area and make it a feature strip. Make a "V" groove at the seam. Better to make it look intentional than to make it look like a patch. (Just a thought)
                              Jason E. Whipple
                              Historic House Restoration
                              Cincinnati, Ohio
                              http://www.facebook.com/RestoreOhio

                              Comment

                              Working...
                              X