Bug and Defect Report Email Address

NOTICE: Thank you for your continued patience with the persistent bugs affecting the JLC Online Forums. We've setup a special email address for reporting issues and defects. Reports will go directly to the assigned IT team members. Please include screenshots if you can. There were some widespread issues over the past weekend which have been resolved. However, we know that various error pop-ups are still occurring during post composition and at other times. Thanks again. Here's the email address:
See more
See less

Spiral fuzz

  • Filter
  • Time
  • Show
Clear All
new posts

  • Spiral fuzz

    Anybody have a quick way to deal with the paper fuzz around spiral cut holes. I find that after it gets soaked with paint, it sometimes interferes with switch plates etc.

  • #2
    Re: Spiral fuzz

    I vaccom out the boxes after sanding and then ater the prime coat is dry I sand lightly to remove the paper fuzz.


    • #3
      Re: Spiral fuzz

      Thanks Myron,

      Current job will get primer (USG FirstCoat) this week, so I'll give it a try.