PDA

View Full Version : curved soffit detail



Kyle
12-31-2003, 12:37 AM
I recently bought a book Will Holladay's "A Roof Cutter's Secret To Framing the Custom Home". In the book there is a interior soffit detail (fig15-5 pg. 287). This soffit is essentially a large quarter round with about a 10' radius. Then where the soffit meets the ceiling and wall, there is a small +-4" radius where is turns on to the wall and ceiling. In other words there are no edges. It is just a series of smooth curves.

My question is... in this detail he has 2x4s spaced out along the large curves, but not the two smaller curves where the soffit turns back to the wall. So how would you go about finishing this. Would you use plaster some sort of mesh? If so then how would you get the mesh to fit the profile of the small curves.

Myron Ferguson
01-08-2004, 10:05 PM
I have never done anything like this.Check out the website www.trimroc.com they have some really nice stuff.